← Illinois

Tap water quality report

Arlington

EPA monitoring tested this supplier for 78 contaminants and detected 21. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

78
contaminants tested
21
detected
250
people served
14
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Bureau

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

14
health-based violations
105
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1999-05-01 → 1999-05-31
MCL Health-based Archived 1999-05-01 → 1999-05-31
TT Health-based Resolved 1996-01-01
TT Health-based Resolved 1996-01-01
TT Health-based Resolved 1996-01-01
TT Health-based Resolved 1995-08-01
MCL Health-based Archived 1995-05-01 → 1995-05-31
MCL Health-based Archived 1995-05-01 → 1995-05-31
MCL Health-based Archived 1995-05-01 → 1995-05-31
MCL Health-based Archived 1995-05-01 → 1995-05-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
24/24 LCR 2025
Copper
397.85 µg/L 31%
of the EPA limit 1300 µg/L
worst single sample: 717 µg/L
14/15 SYR4 2013–2019
Lead
12.635 µg/L 84%
of the EPA limit 15 µg/L
worst single sample: 13.6 µg/L
6/15 SYR4 2013–2019
trans-1,2-Dichloroethylene
1.8 µg/L 1.8%
of the EPA limit 100 µg/L
worst single sample: 2.05 µg/L
5/14 SYR4 2014–2019
Barium
67.3 µg/L 3.4%
of the EPA limit 2000 µg/L
worst single sample: 67.5 µg/L
3/3 SYR4 2012–2018
Fluoride
1160.2 µg/L 29%
of the EPA limit 4000 µg/L
worst single sample: 1220 µg/L
3/3 SYR4 2012–2018
Bromodichloromethane
9.046 µg/L
No EPA limit set
worst single sample: 9.4 µg/L
2/2 SYR4 2014–2017
Bromoform
1.518 µg/L
No EPA limit set
worst single sample: 1.54 µg/L
2/2 SYR4 2014–2017
Chloroform
12.6925 µg/L
No EPA limit set
worst single sample: 13.2 µg/L
2/2 SYR4 2014–2017
Combined Radium (-226 And -228)
0.7766 pCi/L 16%
of the EPA limit 5 pCi/L
worst single sample: 0.7840 pCi/L
2/2 SYR4 2016–2018
Dibromochloromethane
6.679 µg/L
No EPA limit set
worst single sample: 6.9 µg/L
2/2 SYR4 2014–2017
Nitrate
164 µg/L 1.6%
of the EPA limit 10000 µg/L
2/18 SYR4 2012–2019
Nitrite
17.65 µg/L 1.8%
of the EPA limit 1000 µg/L
worst single sample: 18 µg/L
2/11 SYR4 2012–2019
TTHM
29.5395 µg/L 37%
of the EPA limit 80 µg/L
worst single sample: 30.6 µg/L
2/2 SYR4 2014–2017
Total Haloacetic Acids (HAA5)
11.6385 µg/L 19%
of the EPA limit 60 µg/L
worst single sample: 11.7 µg/L
2/2 SYR4 2014–2017
Trichloroacetic Acid
3.007 µg/L
No EPA limit set
worst single sample: 3.1 µg/L
2/2 SYR4 2014–2017
Dibromoacetic Acid
2.6 µg/L
No EPA limit set
1/2 SYR4 2014–2017
Dichloroacetic Acid
6 µg/L
No EPA limit set
1/2 SYR4 2014–2017
Monobromoacetic Acid
1.06 µg/L
No EPA limit set
1/2 SYR4 2014–2017
Monochloroacetic Acid
8.17 µg/L
No EPA limit set
1/2 SYR4 2014–2017
Nitrate-Nitrite
164 µg/L 1.6%
of the EPA limit 10000 µg/L
1/8 SYR4 2012–2019
57 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzene

Utility contact

Contact
KOCH, RICHARD
Phone
815-638-2285
Email
[email protected]

Frequently asked questions about Arlington

Is Arlington tap water safe to drink?

EPA monitoring detected 21 contaminants in Arlington's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Arlington's water?

EPA monitoring detected Lead, Copper, Lead, trans-1,2-Dichloroethylene, Barium, and others. The full list with the level and data source for each is above.

How many people does Arlington serve?

Arlington reports serving 250 people in Illinois, per its EPA record.

Has Arlington had any water quality violations?

The EPA has 105 violations on file for Arlington, of which 14 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.