Tap WaterIndex

← Idaho

Tap water quality report

Kimberly City of

EPA monitoring tested this supplier for 70 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

70
contaminants tested
13
detected
5,359
people served
14
health-based violations
Idaho rankingsLead in IdahoPFAS in Idaho
Water source
Ground water
Ownership
Local government
Counties served
Twin Falls

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

14
health-based violations
48
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2017-08-01
TT Health-based Resolved 2017-08-01
TT Health-based Resolved 2017-08-01
TT Health-based Resolved 2017-08-01
MCL Health-based Resolved 2009-10-01 → 2009-12-31
MCL Health-based Resolved 2009-10-01 → 2009-12-31
MCL Health-based Resolved 2009-10-01 → 2009-12-31
MCL Health-based Resolved 2009-10-01 → 2009-12-31
MCL Health-based Resolved 2009-10-01 → 2009-12-31
MCL Health-based Resolved 2009-10-01 → 2009-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
5630 µg/L 56%
of the EPA limit 10000 µg/L
worst single sample: 5790 µg/L
66/66 SYR4 2012–2019
TTHM
21.22 µg/L 27%
of the EPA limit 80 µg/L
worst single sample: 21.5 µg/L
9/9 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
6.02 µg/L 10%
of the EPA limit 60 µg/L
worst single sample: 6.5 µg/L
9/9 SYR4 2012–2019
Lead
0.0040 mg/L 27%
of the EPA limit 0.0150 mg/L
 8/8 LCR 2025
Combined Uranium
16.65 µg/L 55%
of the EPA limit 30 µg/L
worst single sample: 17.1 µg/L
6/6 SYR4 2012–2019
Combined Radium (-226 And -228)
1.513 pCi/L 30%
of the EPA limit 5 pCi/L
worst single sample: 1.59 pCi/L
3/5 SYR4 2012–2016
Gross Alpha, Excl. Radon And U
7.02 pCi/L 47%
of the EPA limit 15 pCi/L
worst single sample: 7.1 pCi/L
3/6 SYR4 2012–2019
Barium
107.62 µg/L 5.4%
of the EPA limit 2000 µg/L
worst single sample: 111 µg/L
2/2 SYR4 2012–2016
Nitrate-Nitrite
4469 µg/L 45%
of the EPA limit 10000 µg/L
worst single sample: 4470 µg/L
2/2 SYR4 2019
Selenium
2.0005 µg/L 4%
of the EPA limit 50 µg/L
worst single sample: 2.01 µg/L
2/2 SYR4 2012–2016
Arsenic
7.03 µg/L 70%
of the EPA limit 10 µg/L
 1/1 SYR4 2012
Chromium
1.71 µg/L 1.7%
of the EPA limit 100 µg/L
 1/2 SYR4 2012–2016
Fluoride
460 µg/L 12%
of the EPA limit 4000 µg/L
 1/2 SYR4 2012–2019
57 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
REED, BRIAN
Phone
208-423-4151
Email
[email protected]

Frequently asked questions about Kimberly City of

Is Kimberly City of tap water safe to drink?

EPA monitoring detected 13 contaminants in Kimberly City of's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Kimberly City of's water?

EPA monitoring detected Nitrate, TTHM, Total Haloacetic Acids (HAA5), Lead, Combined Uranium, and others. The full list with the level and data source for each is above.

How many people does Kimberly City of serve?

Kimberly City of reports serving 5,359 people in Idaho, per its EPA record.

Has Kimberly City of had any water quality violations?

The EPA has 48 violations on file for Kimberly City of, of which 14 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.