← Iowa

Tap water quality report

Roland Water Supply

EPA monitoring tested this supplier for 58 contaminants and detected 17. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

58
contaminants tested
17
detected
1,394
people served
22
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Story

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

22
health-based violations
26
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30
MCL Health-based Resolved 1994-09-01 → 1994-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
1440 µg/L 111%
of the EPA limit, at the 95th percentile of samples — 1300 µg/L
worst single sample: 4000 µg/L
65/70 SYR4 2014–2017
Lead
30 µg/L 200%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 32 µg/L
21/70 SYR4 2014–2017
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
20/20 LCR 2023
Nitrate
1110 µg/L 11%
of the EPA limit 10000 µg/L
16/16 SYR4 2012–2019
P-Dichlorobenzene
13.4 µg/L 18%
of the EPA limit 75 µg/L
worst single sample: 15 µg/L
9/13 SYR4 2015–2019
Bromodichloromethane
4.2 µg/L
No EPA limit set
worst single sample: 4.3 µg/L
6/7 SYR4 2013–2019
Chloroform
8.75 µg/L
No EPA limit set
worst single sample: 9.1 µg/L
6/7 SYR4 2013–2019
Dibromochloromethane
1.65 µg/L
No EPA limit set
worst single sample: 1.7 µg/L
6/7 SYR4 2013–2019
Dichloroacetic Acid
2.75 µg/L
No EPA limit set
worst single sample: 3 µg/L
6/7 SYR4 2013–2019
TTHM
14 µg/L 18%
of the EPA limit 80 µg/L
6/7 SYR4 2013–2019
Trichloroacetic Acid
3.75 µg/L
No EPA limit set
worst single sample: 4 µg/L
6/7 SYR4 2013–2019
Barium
630 µg/L 32%
of the EPA limit 2000 µg/L
1/1 SYR4 2013
Combined Radium (-226 And -228)
1.2 pCi/L 24%
of the EPA limit 5 pCi/L
1/1 SYR4 2015
Ethylbenzene
2.6 µg/L 0.4%
of the EPA limit 700 µg/L
1/2 SYR4 2015–2017
Fluoride
1900 µg/L 48%
of the EPA limit 4000 µg/L
1/1 SYR4 2013
Total Haloacetic Acids (HAA5)
7 µg/L 12%
of the EPA limit 60 µg/L
1/7 SYR4 2013–2019
Xylenes, Total
19 µg/L 0.2%
of the EPA limit 10000 µg/L
1/2 SYR4 2015–2017
41 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBenzeneBenzo(A)PyreneBromoformChlorobenzeneCadmiumCarbon TetrachlorideChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebLassoMercuryMonobromoacetic AcidMonochloroacetic AcidPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ROLAND WATER SUPPLY
Phone
515-291-7013
Email
[email protected]

Frequently asked questions about Roland Water Supply

Is Roland Water Supply tap water safe to drink?

EPA monitoring detected 17 contaminants in Roland Water Supply's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Roland Water Supply's water?

EPA monitoring detected Copper, Lead, Lead, Nitrate, P-Dichlorobenzene, and others. The full list with the level and data source for each is above.

How many people does Roland Water Supply serve?

Roland Water Supply reports serving 1,394 people in Iowa, per its EPA record.

Has Roland Water Supply had any water quality violations?

The EPA has 26 violations on file for Roland Water Supply, of which 22 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.