Is Park View Water & Sanitary District Tap Water Safe? Quality Report

Water source: Ground water
Ownership: Private
Counties served: Scott

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2004-02-01 → 2004-02-29
MCL	Health-based	Resolved	2004-02-01 → 2004-02-29
MCL	Health-based	Resolved	2004-02-01 → 2004-02-29
MCL	Health-based	Resolved	2004-02-01 → 2004-02-29
MR	Monitoring	Resolved	2010-10-01 → 2011-09-30
MR	Monitoring	Resolved	2010-10-01 → 2011-09-30
MR	Monitoring	Resolved	2010-10-01 → 2011-09-30
MR	Monitoring	Resolved	2010-10-01 → 2011-09-30
MR	Monitoring	Resolved	2002-01-01 → 2002-12-31
MR	Monitoring	Resolved	2002-01-01 → 2002-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Nitrate	1300 µg/L 13% of the EPA limit 10000 µg/L	20/34	SYR4	2012–2019
Copper	984 µg/L 76% of the EPA limit 1300 µg/L worst single sample: 1200 µg/L	19/20	SYR4	2014–2017
Lead	0.0010 mg/L 6.7% of the EPA limit 0.0150 mg/L	19/19	LCR	2025
Lead	8.86 µg/L 59% of the EPA limit 15 µg/L worst single sample: 9 µg/L	15/20	SYR4	2014–2017
Arsenic	4.5 µg/L 45% of the EPA limit 10 µg/L worst single sample: 5 µg/L	6/7	SYR4	2012–2019
Chloroform	23.25 µg/L No EPA limit set worst single sample: 24 µg/L	6/6	SYR4	2013–2019
TTHM	40.8 µg/L 51% of the EPA limit 80 µg/L worst single sample: 44 µg/L	5/7	SYR4	2013–2019
Total Haloacetic Acids (HAA5)	18.55 µg/L 31% of the EPA limit 60 µg/L worst single sample: 19 µg/L	4/7	SYR4	2013–2019
Bromodichloromethane	3.84 µg/L No EPA limit set worst single sample: 4 µg/L	3/6	SYR4	2013–2019
Dichloroacetic Acid	6.9 µg/L No EPA limit set worst single sample: 7 µg/L	3/6	SYR4	2013–2019
Trichloroacetic Acid	9 µg/L No EPA limit set	3/6	SYR4	2013–2019
Barium	601.5 µg/L 30% of the EPA limit 2000 µg/L worst single sample: 610 µg/L	2/2	SYR4	2012–2013
Fluoride	564 µg/L 14% of the EPA limit 4000 µg/L worst single sample: 570 µg/L	2/2	SYR4	2012–2013
Dibromochloromethane	0.6000 µg/L No EPA limit set	1/6	SYR4	2013–2019

48 contaminants tested, none detected

1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAsbestosAtrazineBenzeneBenzo(A)PyreneBromoformChlorobenzeneCadmiumCarbon TetrachlorideChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebDiquatEthylbenzeneGlyphosateLassoMercuryMonobromoacetic AcidMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact: PARK VIEW WATER & SANITARY DISTRICT
Phone: 563-285-7397
Email: [email protected]

Frequently asked questions about Park View Water & Sanitary District

Is Park View Water & Sanitary District tap water safe to drink?

EPA monitoring detected 14 contaminants in Park View Water & Sanitary District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Park View Water & Sanitary District's water?

EPA monitoring detected Nitrate, Copper, Lead, Lead, Arsenic, and others. The full list with the level and data source for each is above.

How many people does Park View Water & Sanitary District serve?

Park View Water & Sanitary District reports serving 2,389 people in Iowa, per its EPA record.

Has Park View Water & Sanitary District had any water quality violations?

The EPA has 43 violations on file for Park View Water & Sanitary District, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.