Is Floyd Muni Water Supply Tap Water Safe? Quality Report

Water source: Ground water
Ownership: Local government
Counties served: Floyd

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2019-10-01 → 2019-12-31
MCL	Health-based	Resolved	2019-10-01 → 2019-12-31
MCL	Health-based	Resolved	2019-10-01 → 2019-12-31
MCL	Health-based	Resolved	2019-10-01 → 2019-12-31
MR	Monitoring	Resolved	2005-07-01 → 2007-08-31
MR	Monitoring	Resolved	2005-07-01 → 2007-08-31
MR	Monitoring	Resolved	2005-07-01 → 2007-08-31
MR	Monitoring	Resolved	2005-07-01 → 2007-08-31
MR	Monitoring	Resolved	2005-07-01 → 2007-08-31
MR	Monitoring	Resolved	2005-07-01 → 2007-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Lead	0.0100 mg/L 67% of the EPA limit 0.0150 mg/L	16/16	LCR	2023
Copper	142.25 µg/L 11% of the EPA limit 1300 µg/L worst single sample: 176 µg/L	10/10	SYR4	2014–2017
Di(2-ethylhexyl) Phthalate	8.61 µg/L 143% of the EPA limit, at the 95th percentile of samples — 6 µg/L worst single sample: 8.7 µg/L	10/14	SYR4	2012–2019
Lead	4.49 µg/L 30% of the EPA limit 15 µg/L worst single sample: 4.7 µg/L	7/10	SYR4	2014–2017
Bromodichloromethane	7.3375 µg/L No EPA limit set worst single sample: 7.39 µg/L	4/4	SYR4	2014–2019
Chloroform	56.075 µg/L No EPA limit set worst single sample: 56.6 µg/L	4/4	SYR4	2014–2019
Dibromochloromethane	5.1145 µg/L No EPA limit set worst single sample: 5.38 µg/L	4/4	SYR4	2014–2019
Dichloroacetic Acid	5.6455 µg/L No EPA limit set worst single sample: 5.95 µg/L	4/4	SYR4	2014–2019
Monochloroacetic Acid	12.23 µg/L No EPA limit set worst single sample: 12.5 µg/L	4/4	SYR4	2014–2019
TTHM	65.365 µg/L 82% of the EPA limit 80 µg/L worst single sample: 65.5 µg/L	4/4	SYR4	2014–2019
Trichloroacetic Acid	3.07 µg/L No EPA limit set worst single sample: 3.16 µg/L	4/4	SYR4	2014–2019
Dibromoacetic Acid	1.498 µg/L No EPA limit set worst single sample: 1.51 µg/L	3/4	SYR4	2014–2019
Total Haloacetic Acids (HAA5)	21.04 µg/L 35% of the EPA limit 60 µg/L worst single sample: 21.3 µg/L	3/4	SYR4	2014–2019
Barium	208.7 µg/L 10% of the EPA limit 2000 µg/L worst single sample: 209 µg/L	2/2	SYR4	2013
Bromoform	1.051 µg/L No EPA limit set worst single sample: 1.08 µg/L	2/4	SYR4	2014–2019
Fluoride	295 µg/L 7.4% of the EPA limit 4000 µg/L worst single sample: 300 µg/L	2/2	SYR4	2013
Combined Radium (-226 And -228)	1 pCi/L 20% of the EPA limit 5 pCi/L	1/2	SYR4	2017

43 contaminants tested, none detected

1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBenzeneBenzo(A)PyreneChlorobenzeneCadmiumCarbon TetrachlorideChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDinosebDiquatEthylbenzeneGlyphosateLassoMercuryMonobromoacetic AcidNitratePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact: FLOYD MUNI WATER SUPPLY
Phone: 641-398-2857
Email: [email protected]

Frequently asked questions about Floyd Muni Water Supply

Is Floyd Muni Water Supply tap water safe to drink?

EPA monitoring detected 17 contaminants in Floyd Muni Water Supply's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Floyd Muni Water Supply's water?

EPA monitoring detected Lead, Copper, Di(2-ethylhexyl) Phthalate, Lead, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Floyd Muni Water Supply serve?

Floyd Muni Water Supply reports serving 313 people in Iowa, per its EPA record.

Has Floyd Muni Water Supply had any water quality violations?

The EPA has 71 violations on file for Floyd Muni Water Supply, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.