← Iowa

Tap water quality report

Wheatland City Water Supply

EPA monitoring tested this supplier for 59 contaminants and detected 21. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

59
contaminants tested
21
detected
775
people served
27
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Clinton

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

27
health-based violations
50
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2017-05-01 → 2017-05-31
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
700.6 µg/L 54%
of the EPA limit 1300 µg/L
worst single sample: 737 µg/L
30/30 SYR4 2013–2019
Nitrate
500 µg/L 5%
of the EPA limit 10000 µg/L
24/28 SYR4 2012–2019
Nitrite
2824 µg/L 282%
of the EPA limit, at the 95th percentile of samples — 1000 µg/L
worst single sample: 3240 µg/L
17/163 SYR4 2012–2019
Bromodichloromethane
4.03 µg/L
No EPA limit set
worst single sample: 6.25 µg/L
16/21 SYR4 2012–2019
Chloroform
2.6625 µg/L
No EPA limit set
worst single sample: 5.25 µg/L
16/21 SYR4 2012–2019
Bromoform
65.48 µg/L
No EPA limit set
worst single sample: 73.6 µg/L
15/21 SYR4 2012–2019
Lead
0.0032 mg/L 21%
of the EPA limit 0.0150 mg/L
15/15 LCR 2025
Total Haloacetic Acids (HAA5)
23.25 µg/L 39%
of the EPA limit 60 µg/L
worst single sample: 30.6 µg/L
15/21 SYR4 2012–2019
Dibromoacetic Acid
8.6345 µg/L
No EPA limit set
worst single sample: 8.68 µg/L
14/21 SYR4 2012–2019
Dibromochloromethane
13.2 µg/L
No EPA limit set
worst single sample: 15.8 µg/L
14/21 SYR4 2012–2019
Monochloroacetic Acid
15.475 µg/L
No EPA limit set
worst single sample: 18.4 µg/L
14/21 SYR4 2012–2019
TTHM
88.425 µg/L 111%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 89.4 µg/L
14/21 SYR4 2012–2019
Trichloroacetic Acid
2.904 µg/L
No EPA limit set
worst single sample: 2.97 µg/L
13/21 SYR4 2012–2019
Dichloroacetic Acid
3.2575 µg/L
No EPA limit set
worst single sample: 3.37 µg/L
6/21 SYR4 2012–2019
Lead
4.42 µg/L 29%
of the EPA limit 15 µg/L
worst single sample: 4.9 µg/L
4/30 SYR4 2013–2019
Xylenes, Total
1.0055 µg/L 0%
of the EPA limit 10000 µg/L
worst single sample: 1.01 µg/L
4/12 SYR4 2012–2018
Monobromoacetic Acid
1.238 µg/L
No EPA limit set
worst single sample: 1.24 µg/L
3/21 SYR4 2012–2019
Arsenic
1.6 µg/L 16%
of the EPA limit 10 µg/L
2/2 SYR4 2015
Barium
172.75 µg/L 8.6%
of the EPA limit 2000 µg/L
worst single sample: 173 µg/L
2/2 SYR4 2015
Fluoride
600 µg/L 15%
of the EPA limit 4000 µg/L
2/2 SYR4 2015
Selenium
3.79 µg/L 7.6%
of the EPA limit 50 µg/L
worst single sample: 3.8 µg/L
2/2 SYR4 2015
38 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBenzeneBenzo(A)PyreneChlorobenzeneCadmiumCarbon TetrachlorideChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylbenzeneLassoMercuryPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WHEATLAND CITY WATER SUPPLY
Phone
563-374-1551
Email
[email protected]

Frequently asked questions about Wheatland City Water Supply

Is Wheatland City Water Supply tap water safe to drink?

EPA monitoring detected 21 contaminants in Wheatland City Water Supply's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Wheatland City Water Supply's water?

EPA monitoring detected Copper, Nitrate, Nitrite, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Wheatland City Water Supply serve?

Wheatland City Water Supply reports serving 775 people in Iowa, per its EPA record.

Has Wheatland City Water Supply had any water quality violations?

The EPA has 50 violations on file for Wheatland City Water Supply, of which 27 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.