Tap WaterIndex

← Iowa

Tap water quality report

Evansdale Water Works

EPA monitoring tested this supplier for 92 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

92
contaminants tested
9
detected
4,561
people served
0
health-based violations
Iowa rankingsLead in IowaPFAS in Iowa
Water source
Ground water
Ownership
Local government
Counties served
Black Hawk

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
16
violations on file
0
still open
ViolationTypeStatusPeriod
MON Monitoring Resolved 2019-06-01 → 2019-06-30
MON Monitoring Resolved 2019-06-01 → 2019-06-30
MON Monitoring Resolved 2019-06-01 → 2019-06-30
MON Monitoring Resolved 2019-06-01 → 2019-06-30
MR Monitoring Resolved 2014-08-01 → 2014-08-31
MR Monitoring Resolved 2014-08-01 → 2014-08-31
MR Monitoring Resolved 2014-08-01 → 2014-08-31
MR Monitoring Resolved 2014-08-01 → 2014-08-31
MR Monitoring Resolved 2014-08-01 → 2014-08-31
MR Monitoring Resolved 2014-08-01 → 2014-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
634.8 µg/L 49%
of the EPA limit 1300 µg/L
worst single sample: 1110 µg/L
60/60 SYR4 2013–2019
Fluoride
879 µg/L 22%
of the EPA limit 4000 µg/L
worst single sample: 970 µg/L
15/15 SYR4 2012–2014
Lead
75.69 µg/L 505%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 106 µg/L
15/60 SYR4 2013–2019
Lead
0.0012 mg/L 8%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2025
Barium
81.68 µg/L 4.1%
of the EPA limit 2000 µg/L
worst single sample: 81.8 µg/L
2/2 SYR4 2013–2014
Chloroform
0.6085 µg/L
No EPA limit set
worst single sample: 0.6100 µg/L
2/7 SYR4 2013–2019
Dichloroacetic Acid
1.754 µg/L
No EPA limit set
worst single sample: 1.76 µg/L
2/7 SYR4 2013–2019
Trichloroacetic Acid
0.6050 µg/L
No EPA limit set
worst single sample: 0.6100 µg/L
2/7 SYR4 2013–2019
Combined Radium (-226 And -228)
3.4 pCi/L 68%
of the EPA limit 5 pCi/L
 1/3 SYR4 2012–2015
83 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAsbestosAtrazineBenzeneBenzo(A)PyreneBromodichloromethaneBromoformChlorobenzeneCadmiumCarbon TetrachlorideChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDibromochloromethaneDinosebDiquatEthylbenzeneGlyphosateHfpo-DaLassoMercuryMonobromoacetic AcidMonochloroacetic AcidNetfosaaNfdhaNmefosaaNitrateNitritePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumSimazineStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)TrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
EVANSDALE WATER WORKS
Phone
319-231-4717
Email
[email protected]

Frequently asked questions about Evansdale Water Works

Is Evansdale Water Works tap water safe to drink?

EPA monitoring detected 9 contaminants in Evansdale Water Works's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Evansdale Water Works's water?

EPA monitoring detected Copper, Fluoride, Lead, Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Evansdale Water Works serve?

Evansdale Water Works reports serving 4,561 people in Iowa, per its EPA record.

Has Evansdale Water Works had any water quality violations?

The EPA has 16 violations on file for Evansdale Water Works, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.