Is J & J Mhp Tap Water Safe? Quality Report

Water source: Ground water
Ownership: Private
Counties served: Kent

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2014-04-01 → 2014-04-30
MCL	Health-based	Resolved	2014-04-01 → 2014-04-30
MCL	Health-based	Resolved	2014-04-01 → 2014-04-30
MCL	Health-based	Resolved	2014-04-01 → 2014-04-30
MCL	Health-based	Resolved	2012-12-01 → 2012-12-31
MCL	Health-based	Resolved	2012-12-01 → 2012-12-31
MCL	Health-based	Resolved	2012-12-01 → 2012-12-31
MCL	Health-based	Resolved	2012-12-01 → 2012-12-31
MCL	Health-based	Resolved	2006-07-01 → 2006-07-31
MCL	Health-based	Resolved	2006-07-01 → 2006-07-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Copper	8.264 µg/L 0.6% of the EPA limit 1300 µg/L worst single sample: 10 µg/L	8/16	SYR4	2014–2019
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	8/8	LCR	2021
Combined Radium (-226 And -228)	1.3688 pCi/L 27% of the EPA limit 5 pCi/L worst single sample: 1.492 pCi/L	3/4	SYR4	2012–2016
Fluoride	66.1 µg/L 1.7% of the EPA limit 4000 µg/L	1/7	SYR4	2012–2019
Lead	0.6700 µg/L 4.5% of the EPA limit 15 µg/L	1/16	SYR4	2014–2019

40 contaminants tested, none detected

1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBariumBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideChloroformChromiumDichloromethaneDibromochloromethaneEthylene DibromideEthylbenzeneMercuryNitrateNitrate-NitriteNitriteSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact: COLEMAN, ROBERT
Phone: 302-363-3619
Email: [email protected]

Frequently asked questions about J & J Mhp

Is J & J Mhp tap water safe to drink?

EPA monitoring detected 5 contaminants in J & J Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in J & J Mhp's water?

EPA monitoring detected Copper, Lead, Combined Radium (-226 And -228), Fluoride, Lead. The full list with the level and data source for each is above.

How many people does J & J Mhp serve?

J & J Mhp reports serving 84 people in Delaware, per its EPA record.

Has J & J Mhp had any water quality violations?

The EPA has 42 violations on file for J & J Mhp, of which 25 are health-based (a contaminant limit or required treatment was breached) and 2 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.