← Delaware

Tap water quality report

Mt Pleasant Mhp, Llc

EPA monitoring tested this supplier for 51 contaminants and detected 7. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

51
contaminants tested
7
detected
117
people served
19
health-based violations
Water source
Ground water
Ownership
Private
Counties served
New Castle

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

19
health-based violations
54
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2011-09-01 → 2011-09-30
MCL Health-based Resolved 2011-09-01 → 2011-09-30
MCL Health-based Resolved 2011-09-01 → 2011-09-30
MCL Health-based Resolved 2011-09-01 → 2011-09-30
MCL Health-based Resolved 2002-12-01 → 2002-12-31
MCL Health-based Resolved 2002-12-01 → 2002-12-31
MCL Health-based Resolved 2002-12-01 → 2002-12-31
MCL Health-based Archived 2001-04-01 → 2001-04-30
MCL Health-based Resolved 2001-04-01 → 2001-04-30
MCL Health-based Resolved 2001-04-01 → 2001-04-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
258.9 µg/L 20%
of the EPA limit 1300 µg/L
worst single sample: 583 µg/L
15/21 SYR4 2012–2017
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
14/14 LCR 2025
Fluoride
220 µg/L 5.5%
of the EPA limit 4000 µg/L
8/8 SYR4 2012–2019
Lead
4.1 µg/L 27%
of the EPA limit 15 µg/L
worst single sample: 4.2 µg/L
2/21 SYR4 2012–2017
Barium
186.2 µg/L 9.3%
of the EPA limit 2000 µg/L
1/1 SYR4 2012
Chromium
2.4 µg/L 2.4%
of the EPA limit 100 µg/L
1/1 SYR4 2012
Combined Radium (-226 And -228)
2.4 pCi/L 48%
of the EPA limit 5 pCi/L
1/1 SYR4 2018
44 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCadmiumCarbon TetrachlorideChloroformDichloromethaneDibromoacetic AcidDibromochloromethaneDichloroacetic AcidEthylene DibromideEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitriteSeleniumStyreneTTHMTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
STEWARD, GEORGE
Phone
610-550-1315
Email
[email protected]

Frequently asked questions about Mt Pleasant Mhp, Llc

Is Mt Pleasant Mhp, Llc tap water safe to drink?

EPA monitoring detected 7 contaminants in Mt Pleasant Mhp, Llc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Mt Pleasant Mhp, Llc's water?

EPA monitoring detected Copper, Lead, Fluoride, Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Mt Pleasant Mhp, Llc serve?

Mt Pleasant Mhp, Llc reports serving 117 people in Delaware, per its EPA record.

Has Mt Pleasant Mhp, Llc had any water quality violations?

The EPA has 54 violations on file for Mt Pleasant Mhp, Llc, of which 19 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.