← Connecticut

Tap water quality report

Scwa, Hillcrest Division (Hlc)

EPA monitoring tested this supplier for 80 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

80
contaminants tested
18
detected
450
people served
0
health-based violations
Water source
SWP
Ownership
Local government
Counties served
New London

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
6
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2004-07-01
Other Monitoring Resolved 2004-07-01
MR Monitoring Resolved 1993-07-01 → 1993-12-31
MR Monitoring Resolved 1993-07-01 → 1993-12-31
MR Monitoring Resolved 1993-07-01 → 1993-12-31
MR Monitoring Resolved 1993-07-01 → 1993-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
21.35 µg/L
No EPA limit set
worst single sample: 22 µg/L
54/54 SYR4 2012–2019
Chloroform
76.35 µg/L
No EPA limit set
worst single sample: 81 µg/L
54/54 SYR4 2012–2019
Dibromochloromethane
6.135 µg/L
No EPA limit set
worst single sample: 6.5 µg/L
54/54 SYR4 2012–2019
TTHM
104.65 µg/L 131%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 108.5 µg/L
51/51 SYR4 2012–2019
Bromoform
1.1 µg/L
No EPA limit set
worst single sample: 2.1 µg/L
24/54 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
32.85 µg/L 55%
of the EPA limit 60 µg/L
worst single sample: 38 µg/L
24/50 SYR4 2012–2019
Nitrate
1040 µg/L 10%
of the EPA limit 10000 µg/L
18/18 SYR4 2012–2019
Dichloroacetic Acid
12.2 µg/L
No EPA limit set
worst single sample: 13 µg/L
17/50 SYR4 2012–2019
Dibromoacetic Acid
1.73 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
15/50 SYR4 2012–2019
Copper
184.6 µg/L 14%
of the EPA limit 1300 µg/L
worst single sample: 241 µg/L
13/13 SYR4 2014–2018
Lead
0.00090 mg/L 6%
of the EPA limit 0.0150 mg/L
9/9 LCR 2023
Nitrate-Nitrite
884 µg/L 8.8%
of the EPA limit 10000 µg/L
worst single sample: 1040 µg/L
9/9 SYR4 2012–2019
Trichloroacetic Acid
18.75 µg/L
No EPA limit set
worst single sample: 19 µg/L
6/50 SYR4 2012–2019
Combined Uranium
1.578 µg/L 5.3%
of the EPA limit 30 µg/L
worst single sample: 1.6 µg/L
3/3 SYR4 2013–2019
Barium
3 µg/L 0.2%
of the EPA limit 2000 µg/L
2/3 SYR4 2012–2018
Monochloroacetic Acid
7.685 µg/L
No EPA limit set
worst single sample: 7.8 µg/L
2/50 SYR4 2012–2019
Beryllium, Total
0.3000 µg/L 7.5%
of the EPA limit 4 µg/L
1/3 SYR4 2012–2018
Lead
2 µg/L 13%
of the EPA limit 15 µg/L
1/13 SYR4 2014–2018
62 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndrinEthylbenzeneFluorideGlyphosateGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
CANSLER, JOSEPH
Phone
860-464-0232
Email
[email protected]

Frequently asked questions about Scwa, Hillcrest Division (Hlc)

Is Scwa, Hillcrest Division (Hlc) tap water safe to drink?

EPA monitoring detected 18 contaminants in Scwa, Hillcrest Division (Hlc)'s water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Scwa, Hillcrest Division (Hlc)'s water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, Bromoform, and others. The full list with the level and data source for each is above.

How many people does Scwa, Hillcrest Division (Hlc) serve?

Scwa, Hillcrest Division (Hlc) reports serving 450 people in Connecticut, per its EPA record.

Has Scwa, Hillcrest Division (Hlc) had any water quality violations?

The EPA has 6 violations on file for Scwa, Hillcrest Division (Hlc), of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.