Tap WaterIndex

← California

Tap water quality report

Strathmore Public Util Dist

EPA monitoring tested this supplier for 62 contaminants and detected 17. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

62
contaminants tested
17
detected
2,669
people served
179
health-based violations
California rankingsLead in CaliforniaPFAS in California
Water source
Surface water
Ownership
Local government
Counties served
Tulare

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

179
health-based violations
187
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1992-06-01 → 1992-06-30
MCL Health-based Resolved 1992-06-01 → 1992-06-30
MCL Health-based Resolved 1992-05-01 → 1994-03-01
MCL Health-based Resolved 1992-05-01 → 1994-03-01
MCL Health-based Archived 1989-12-01 → 1989-12-31
MCL Health-based Archived 1989-11-01 → 1989-11-30
MCL Health-based Archived 1989-10-01 → 1989-10-31
MCL Health-based Archived 1989-09-01 → 1989-09-30
MCL Health-based Archived 1989-08-01 → 1989-08-31
MCL Health-based Archived 1989-07-01 → 1989-07-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
13000 µg/L 130%
of the EPA limit, at the 95th percentile of samples — 10000 µg/L
worst single sample: 15594 µg/L
856/920 SYR4 2012–2019
Bromodichloromethane
21 µg/L
No EPA limit set
worst single sample: 23 µg/L
50/50 SYR4 2013–2019
Chloroform
73.5 µg/L
No EPA limit set
worst single sample: 120 µg/L
50/50 SYR4 2013–2019
Dichloroacetic Acid
36.55 µg/L
No EPA limit set
worst single sample: 91 µg/L
50/50 SYR4 2013–2019
TTHM
94.55 µg/L 118%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 120 µg/L
50/50 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
79.1 µg/L 132%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 210 µg/L
50/50 SYR4 2013–2019
Trichloroacetic Acid
46.2 µg/L
No EPA limit set
worst single sample: 110 µg/L
50/50 SYR4 2013–2019
Dibromochloromethane
10.8 µg/L
No EPA limit set
worst single sample: 13 µg/L
45/50 SYR4 2013–2019
Dibromoacetic Acid
3.15 µg/L
No EPA limit set
worst single sample: 3.6 µg/L
31/50 SYR4 2013–2019
Monochloroacetic Acid
5.78 µg/L
No EPA limit set
worst single sample: 6.5 µg/L
17/50 SYR4 2013–2019
Lead
0.0130 mg/L 87%
of the EPA limit 0.0150 mg/L
 16/16 LCR 2024
Bromoform
2.15 µg/L
No EPA limit set
worst single sample: 2.7 µg/L
12/50 SYR4 2013–2019
Barium
130 µg/L 6.5%
of the EPA limit 2000 µg/L
 3/11 SYR4 2012–2019
Fluoride
160 µg/L 4%
of the EPA limit 4000 µg/L
 3/11 SYR4 2012–2019
Monobromoacetic Acid
8.66 µg/L
No EPA limit set
worst single sample: 9.5 µg/L
3/50 SYR4 2013–2019
Arsenic
2.2 µg/L 22%
of the EPA limit 10 µg/L
 1/11 SYR4 2012–2019
Nitrate-Nitrite
12000 µg/L 120%
of the EPA limit, at the 95th percentile of samples — 10000 µg/L
 1/4 SYR4 2017–2019
45 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAsbestosAtrazineBenzeneBeryllium, TotalChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneDalaponDinosebEthylene DibromideEndothallEthylbenzeneLassoLeadMercuryNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ORDONEZ, ADRIAN
Phone
559-568-1613
Email
[email protected]

Frequently asked questions about Strathmore Public Util Dist

Is Strathmore Public Util Dist tap water safe to drink?

EPA monitoring detected 17 contaminants in Strathmore Public Util Dist's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Strathmore Public Util Dist's water?

EPA monitoring detected Nitrate, Bromodichloromethane, Chloroform, Dichloroacetic Acid, TTHM, and others. The full list with the level and data source for each is above.

How many people does Strathmore Public Util Dist serve?

Strathmore Public Util Dist reports serving 2,669 people in California, per its EPA record.

Has Strathmore Public Util Dist had any water quality violations?

The EPA has 187 violations on file for Strathmore Public Util Dist, of which 179 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.