← California

Tap water quality report

Bellflower Municipal Water

EPA monitoring tested this supplier for 111 contaminants and detected 20. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

111
contaminants tested
20
detected
5,999
people served
6
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Los Angeles

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

6
health-based violations
6
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2009-06-01 → 2009-06-30
MCL Health-based Resolved 2009-06-01 → 2009-06-30
MCL Health-based Resolved 2006-02-01 → 2006-02-28
MCL Health-based Resolved 2006-02-01 → 2006-02-28
MCL Health-based Resolved 1996-09-16 → 1997-05-07
MCL Health-based Resolved 1996-09-16 → 1997-05-07

PFAS detected

PFAS are industrial “forever chemicals”. These are the EPA's latest nationwide test results (2023–2025).
ContaminantMaxDetection ratePeriod
PFOS 0.0326 µg/L 6/6 2025
PFHXS 0.0056 µg/L 5/6 2025
PFOA 0.0076 µg/L 4/6 2025
Pfba 0.0052 µg/L 1/6 2025

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
44.425 µg/L 56%
of the EPA limit 80 µg/L
worst single sample: 56.1 µg/L
44/65 SYR4 2012–2019
Bromoform
5.01 µg/L
No EPA limit set
worst single sample: 5.6 µg/L
39/65 SYR4 2012–2019
Dibromochloromethane
15.22 µg/L
No EPA limit set
worst single sample: 19.8 µg/L
35/65 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
29/29 LCR 2024
Nitrate
990 µg/L 9.9%
of the EPA limit 10000 µg/L
20/26 SYR4 2012–2019
Fluoride
910 µg/L 23%
of the EPA limit 4000 µg/L
12/12 SYR4 2012–2019
Combined Uranium
3.725 µg/L 12%
of the EPA limit 30 µg/L
8/8 SYR4 2012–2019
Bromodichloromethane
16.025 µg/L
No EPA limit set
worst single sample: 16.7 µg/L
6/65 SYR4 2012–2019
Barium
172 µg/L 8.6%
of the EPA limit 2000 µg/L
worst single sample: 180 µg/L
5/6 SYR4 2012–2017
Dibromoacetic Acid
6 µg/L
No EPA limit set
worst single sample: 6.2 µg/L
5/62 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
20.12 µg/L 34%
of the EPA limit 60 µg/L
worst single sample: 20.7 µg/L
5/62 SYR4 2012–2019
Arsenic
4.37 µg/L 44%
of the EPA limit 10 µg/L
worst single sample: 4.4 µg/L
4/6 SYR4 2012–2017
Chloroform
14.34 µg/L
No EPA limit set
worst single sample: 14.4 µg/L
4/65 SYR4 2012–2019
Dichloroacetic Acid
8.955 µg/L
No EPA limit set
worst single sample: 9 µg/L
4/62 SYR4 2012–2019
Trichloroacetic Acid
5.425 µg/L
No EPA limit set
worst single sample: 5.5 µg/L
4/62 SYR4 2012–2019
Nitrate-Nitrite
740000 µg/L 7400%
of the EPA limit, at the 95th percentile of samples — 10000 µg/L
1/4 SYR4 2012
91 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,3,7,8-TCDD2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCopperCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNetfosaaNfdhaNmefosaaNitriteOxamylPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPfmbaPfmpaPFNAPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
NIETO, CHRISTOPHER
Phone
626-614-2509
Email
[email protected]

Frequently asked questions about Bellflower Municipal Water

Is Bellflower Municipal Water tap water safe to drink?

EPA monitoring detected 20 contaminants in Bellflower Municipal Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bellflower Municipal Water's water?

EPA monitoring detected TTHM, Bromoform, Dibromochloromethane, Lead, Nitrate, and others. The full list with the level and data source for each is above.

How many people does Bellflower Municipal Water serve?

Bellflower Municipal Water reports serving 5,999 people in California, per its EPA record.

Has Bellflower Municipal Water had any water quality violations?

The EPA has 6 violations on file for Bellflower Municipal Water, of which 6 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.