Tap WaterIndex

← Missouri

Tap water quality report

Cs High Country Pines Water Company

EPA monitoring tested this supplier for 57 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

57
contaminants tested
5
detected
668
people served
0
health-based violations
Missouri rankingsLead in MissouriPFAS in Missouri
Water source
Ground water
Ownership
Private
Counties served
Navajo

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
92
violations on file
0
still open
ViolationTypeStatusPeriod
RPT Monitoring Resolved 2025-07-02
RPT Monitoring Resolved 2025-07-02
Other Monitoring Resolved 2025-02-20
Other Monitoring Resolved 2025-02-20
RPT Monitoring Resolved 2024-02-01
RPT Monitoring Resolved 2024-02-01
MR Monitoring Resolved 2024-01-01
MR Monitoring Resolved 2024-01-01
MON Monitoring Resolved 2024-01-01 → 2024-01-31
MON Monitoring Resolved 2024-01-01 → 2024-01-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
300 µg/L 3%
of the EPA limit 10000 µg/L
 16/16 SYR4 2012–2019
Lead
0.0110 mg/L 73%
of the EPA limit 0.0150 mg/L
 11/11 LCR 2027
Copper
321.15 µg/L 25%
of the EPA limit 1300 µg/L
worst single sample: 390 µg/L
10/10 SYR4 2014–2017
Lead
5.152 µg/L 34%
of the EPA limit 15 µg/L
worst single sample: 5.35 µg/L
4/10 SYR4 2014–2017
TTHM
2.82 µg/L 3.5%
of the EPA limit 80 µg/L
 1/2 SYR4 2016–2019
52 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,3,7,8-TCDD2,4,5-TP2,4-DAtrazineBhc-GammaBenzeneBenzo(A)PyreneChlorobenzeneCarbofuranCarbon TetrachlorideChlordaneCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneTolueneTotal Haloacetic Acids (HAA5)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
KRIESS, FRED
Phone
602-698-9786
Email
[email protected]

Frequently asked questions about Cs High Country Pines Water Company

Is Cs High Country Pines Water Company tap water safe to drink?

EPA monitoring detected 5 contaminants in Cs High Country Pines Water Company's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Cs High Country Pines Water Company's water?

EPA monitoring detected Nitrate, Lead, Copper, Lead, TTHM. The full list with the level and data source for each is above.

How many people does Cs High Country Pines Water Company serve?

Cs High Country Pines Water Company reports serving 668 people in Missouri, per its EPA record.

Has Cs High Country Pines Water Company had any water quality violations?

The EPA has 92 violations on file for Cs High Country Pines Water Company, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.