← Arkansas

Tap water quality report

Pike City Water Assn

EPA monitoring tested this supplier for 14 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
11
detected
333
people served
79
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Pike

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

79
health-based violations
102
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2016-10-01 → 2016-12-31
MCL Health-based Resolved 2016-10-01 → 2016-12-31
MCL Health-based Resolved 2016-10-01 → 2016-12-31
MCL Health-based Resolved 2016-10-01 → 2016-12-31
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-04-01 → 2010-06-30
MCL Health-based Resolved 2010-01-01 → 2010-03-31
MCL Health-based Resolved 2010-01-01 → 2010-03-31
MCL Health-based Resolved 2010-01-01 → 2010-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
8.69 µg/L
No EPA limit set
worst single sample: 9.9 µg/L
42/42 SYR4 2014–2019
Chloroform
90.845 µg/L
No EPA limit set
worst single sample: 96.8 µg/L
42/42 SYR4 2014–2019
TTHM
98.15 µg/L 123%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 104 µg/L
42/42 SYR4 2014–2019
Dichloroacetic Acid
29.66 µg/L
No EPA limit set
worst single sample: 35.3 µg/L
37/42 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
68.32 µg/L 114%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 75.5 µg/L
37/42 SYR4 2014–2019
Trichloroacetic Acid
36.12 µg/L
No EPA limit set
worst single sample: 37.1 µg/L
29/42 SYR4 2014–2019
Copper
383.6 µg/L 30%
of the EPA limit 1300 µg/L
worst single sample: 404 µg/L
13/40 SYR4 2013–2019
Monochloroacetic Acid
3.33 µg/L
No EPA limit set
worst single sample: 3.6 µg/L
10/42 SYR4 2014–2019
Lead
0.0270 mg/L 180%
above the EPA limit of 0.0150 mg/L
8/8 LCR 2016
Dibromochloromethane
1.875 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
6/42 SYR4 2014–2019
Lead
52 µg/L 347%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
1/40 SYR4 2013–2019
3 contaminants tested, none detected
BromoformDibromoacetic AcidMonobromoacetic Acid

Utility contact

Contact
CRABTREE, JUSTIN
Phone
870-210-1238

Frequently asked questions about Pike City Water Assn

Is Pike City Water Assn tap water safe to drink?

EPA monitoring detected 11 contaminants in Pike City Water Assn's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Pike City Water Assn's water?

EPA monitoring detected Bromodichloromethane, Chloroform, TTHM, Dichloroacetic Acid, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Pike City Water Assn serve?

Pike City Water Assn reports serving 333 people in Arkansas, per its EPA record.

Has Pike City Water Assn had any water quality violations?

The EPA has 102 violations on file for Pike City Water Assn, of which 79 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.