Is Shannon Hills Water Dept Tap Water Safe? Quality Report

Water source: SWP
Ownership: Local government
Counties served: Saline

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2011-09-01 → 2011-09-30
MCL	Health-based	Resolved	2011-09-01 → 2011-09-30
MCL	Health-based	Resolved	2011-09-01 → 2011-09-30
MON	Monitoring	Resolved	2018-12-01 → 2018-12-31
MON	Monitoring	Resolved	2018-12-01 → 2018-12-31
MR	Monitoring	Resolved	2014-07-01 → 2014-07-31
MR	Monitoring	Resolved	2014-07-01 → 2014-07-31
MR	Monitoring	Resolved	2014-07-01 → 2014-07-31
MR	Monitoring	Resolved	2001-02-01 → 2001-02-28
MR	Monitoring	Archived	1991-06-01 → 1991-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Dichloroacetic Acid	14.585 µg/L No EPA limit set worst single sample: 19.9 µg/L	64/64	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	29.845 µg/L 50% of the EPA limit 60 µg/L worst single sample: 40.1 µg/L	64/64	SYR4	2012–2019
Trichloroacetic Acid	14.685 µg/L No EPA limit set worst single sample: 17.2 µg/L	62/64	SYR4	2012–2019
Bromodichloromethane	9.3 µg/L No EPA limit set worst single sample: 10.4 µg/L	61/61	SYR4	2012–2019
Chloroform	72.9 µg/L No EPA limit set worst single sample: 86.1 µg/L	61/61	SYR4	2012–2019
TTHM	84.5 µg/L 106% of the EPA limit, at the 95th percentile of samples — 80 µg/L worst single sample: 95.9 µg/L	61/61	SYR4	2012–2019
Dibromochloromethane	2 µg/L No EPA limit set worst single sample: 2.5 µg/L	41/61	SYR4	2012–2019
Copper	186.6 µg/L 14% of the EPA limit 1300 µg/L worst single sample: 244 µg/L	15/50	SYR4	2012–2018
Lead	0.0010 mg/L 6.7% of the EPA limit 0.0150 mg/L	11/11	LCR	2025
Monochloroacetic Acid	3.48 µg/L No EPA limit set worst single sample: 3.5 µg/L	5/64	SYR4	2012–2019
Lead	1 µg/L 6.7% of the EPA limit 15 µg/L	4/50	SYR4	2012–2018
Monobromoacetic Acid	2.21 µg/L No EPA limit set worst single sample: 2.3 µg/L	4/64	SYR4	2012–2019
Dibromoacetic Acid	10.975 µg/L No EPA limit set worst single sample: 11.3 µg/L	2/64	SYR4	2012–2019

31 contaminants tested, none detected

11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaBromoformHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact: HAMBY, KIM
Phone: 501-455-2003
Email: [email protected]

Frequently asked questions about Shannon Hills Water Dept

Is Shannon Hills Water Dept tap water safe to drink?

EPA monitoring detected 13 contaminants in Shannon Hills Water Dept's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Shannon Hills Water Dept's water?

EPA monitoring detected Dichloroacetic Acid, Total Haloacetic Acids (HAA5), Trichloroacetic Acid, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Shannon Hills Water Dept serve?

Shannon Hills Water Dept reports serving 3,832 people in Arkansas, per its EPA record.

Has Shannon Hills Water Dept had any water quality violations?

The EPA has 15 violations on file for Shannon Hills Water Dept, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.