← Arkansas

Tap water quality report

Bryant Waterworks

EPA monitoring tested this supplier for 45 contaminants and detected 14. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

45
contaminants tested
14
detected
19,607
people served
15
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Saline

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

15
health-based violations
21
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2014-07-01 → 2014-07-31
MCL Health-based Resolved 2014-07-01 → 2014-07-31
MCL Health-based Resolved 2014-07-01 → 2014-07-31
MCL Health-based Resolved 2010-07-01 → 2010-07-31
MCL Health-based Resolved 2010-07-01 → 2010-07-31
MCL Health-based Resolved 2010-07-01 → 2010-07-31
MCL Health-based Resolved 2010-07-01 → 2010-07-31
MCL Health-based Resolved 2008-01-01 → 2008-03-31
MCL Health-based Resolved 2008-01-01 → 2008-03-31
MCL Health-based Resolved 2007-06-01 → 2007-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Dichloroacetic Acid
14.3 µg/L
No EPA limit set
worst single sample: 18.5 µg/L
128/128 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
27.9 µg/L 47%
of the EPA limit 60 µg/L
worst single sample: 36.3 µg/L
128/128 SYR4 2012–2019
Trichloroacetic Acid
15.2 µg/L
No EPA limit set
worst single sample: 17.5 µg/L
128/128 SYR4 2012–2019
Bromodichloromethane
10.285 µg/L
No EPA limit set
worst single sample: 10.8 µg/L
124/124 SYR4 2012–2019
Chloroform
76.98 µg/L
No EPA limit set
worst single sample: 103 µg/L
124/124 SYR4 2012–2019
TTHM
86.285 µg/L 108%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 112 µg/L
124/124 SYR4 2012–2019
Dibromochloromethane
2.03 µg/L
No EPA limit set
worst single sample: 2.4 µg/L
75/124 SYR4 2012–2019
Copper
64.72 µg/L 5%
of the EPA limit 1300 µg/L
worst single sample: 83 µg/L
23/61 SYR4 2014–2017
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
13/13 LCR 2025
Monochloroacetic Acid
3.12 µg/L
No EPA limit set
worst single sample: 3.3 µg/L
13/128 SYR4 2012–2019
Chlorite
306.5 µg/L 31%
of the EPA limit 1000 µg/L
worst single sample: 315 µg/L
6/6 SYR4 2014
Lead
7.6 µg/L 51%
of the EPA limit 15 µg/L
worst single sample: 9 µg/L
5/61 SYR4 2014–2017
Monobromoacetic Acid
2.125 µg/L
No EPA limit set
worst single sample: 2.2 µg/L
4/128 SYR4 2012–2019
Dibromoacetic Acid
1 µg/L
No EPA limit set
1/128 SYR4 2012–2019
31 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaBromoformHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
WINKEL, MORIAH
Phone
501-943-0452
Email
[email protected]

Frequently asked questions about Bryant Waterworks

Is Bryant Waterworks tap water safe to drink?

EPA monitoring detected 14 contaminants in Bryant Waterworks's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bryant Waterworks's water?

EPA monitoring detected Dichloroacetic Acid, Total Haloacetic Acids (HAA5), Trichloroacetic Acid, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Bryant Waterworks serve?

Bryant Waterworks reports serving 19,607 people in Arkansas, per its EPA record.

Has Bryant Waterworks had any water quality violations?

The EPA has 21 violations on file for Bryant Waterworks, of which 15 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.