Is Moro Waterworks Tap Water Safe? Quality Report

Water source: GWP
Ownership: Local government
Counties served: Lee

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

193

health-based violations

222

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Archived	2024-04-01 → 2024-06-30
MCL	Health-based	Archived	2024-04-01 → 2024-06-30
MCL	Health-based	Archived	2024-04-01 → 2024-06-30
MCL	Health-based	Archived	2024-01-01 → 2024-03-31
MCL	Health-based	Archived	2024-01-01 → 2024-03-31
MCL	Health-based	Archived	2024-01-01 → 2024-03-31
MCL	Health-based	Archived	2023-10-01 → 2023-12-31
MCL	Health-based	Archived	2023-10-01 → 2023-12-31
MCL	Health-based	Archived	2023-10-01 → 2023-12-31
MCL	Health-based	Archived	2023-07-01 → 2023-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Dibromoacetic Acid	18.085 µg/L No EPA limit set worst single sample: 21 µg/L	40/40	SYR4	2014–2019
Total Haloacetic Acids (HAA5)	19.19 µg/L 32% of the EPA limit 60 µg/L worst single sample: 23.4 µg/L	40/40	SYR4	2014–2019
Bromoform	108.3 µg/L No EPA limit set worst single sample: 130 µg/L	39/39	SYR4	2014–2019
Dibromochloromethane	11.36 µg/L No EPA limit set worst single sample: 12.4 µg/L	39/39	SYR4	2014–2019
TTHM	116.3 µg/L 145% of the EPA limit, at the 95th percentile of samples — 80 µg/L worst single sample: 137 µg/L	39/39	SYR4	2014–2019
Monobromoacetic Acid	2.985 µg/L No EPA limit set worst single sample: 3.1 µg/L	24/40	SYR4	2014–2019
Bromodichloromethane	2.275 µg/L No EPA limit set worst single sample: 2.3 µg/L	6/39	SYR4	2014–2019
Dichloroacetic Acid	1.095 µg/L No EPA limit set worst single sample: 1.1 µg/L	2/40	SYR4	2014–2019
Lead	0.0070 mg/L 47% of the EPA limit 0.0150 mg/L	1/1	LCR	1992

3 contaminants tested, none detected

ChloroformMonochloroacetic AcidTrichloroacetic Acid

Utility contact

Contact: WALDRIP, DAVID
Phone: 870-768-4600

Frequently asked questions about Moro Waterworks

Is Moro Waterworks tap water safe to drink?

EPA monitoring detected 9 contaminants in Moro Waterworks's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Moro Waterworks's water?

EPA monitoring detected Dibromoacetic Acid, Total Haloacetic Acids (HAA5), Bromoform, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Moro Waterworks serve?

Moro Waterworks reports serving 219 people in Arkansas, per its EPA record.

Has Moro Waterworks had any water quality violations?

The EPA has 222 violations on file for Moro Waterworks, of which 193 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.