Is Mountain Pine Waterworks Tap Water Safe? Quality Report

Water source: SWP
Ownership: Local government
Counties served: Garland

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2007-09-01 → 2007-09-30
MCL	Health-based	Resolved	2007-09-01 → 2007-09-30
MCL	Health-based	Resolved	2007-09-01 → 2007-09-30
MCL	Health-based	Resolved	2005-08-01 → 2005-08-31
MCL	Health-based	Resolved	2005-08-01 → 2005-08-31
MCL	Health-based	Resolved	2005-08-01 → 2005-08-31
MCL	Health-based	Resolved	2005-08-01 → 2005-08-31
MCL	Health-based	Resolved	2004-06-01 → 2004-06-30
MCL	Health-based	Resolved	2004-06-01 → 2004-06-30
MCL	Health-based	Resolved	2004-06-01 → 2004-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Bromodichloromethane	7.05 µg/L No EPA limit set worst single sample: 8.6 µg/L	50/50	SYR4	2012–2019
Chloroform	78.97 µg/L No EPA limit set worst single sample: 109 µg/L	50/50	SYR4	2012–2019
TTHM	85.11 µg/L 106% of the EPA limit, at the 95th percentile of samples — 80 µg/L worst single sample: 117 µg/L	50/50	SYR4	2012–2019
Dichloroacetic Acid	22.2 µg/L No EPA limit set worst single sample: 29.3 µg/L	49/49	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	36.54 µg/L 61% of the EPA limit 60 µg/L worst single sample: 44.9 µg/L	49/49	SYR4	2012–2019
Trichloroacetic Acid	15.18 µg/L No EPA limit set worst single sample: 18.6 µg/L	48/49	SYR4	2012–2019
Monochloroacetic Acid	3.74 µg/L No EPA limit set worst single sample: 4.3 µg/L	8/49	SYR4	2012–2019
Copper	259 µg/L 20% of the EPA limit 1300 µg/L worst single sample: 310 µg/L	7/30	SYR4	2012–2018
Lead	0.0090 mg/L 60% of the EPA limit 0.0150 mg/L	7/7	LCR	2003
Lead	4.96 µg/L 33% of the EPA limit 15 µg/L worst single sample: 5.4 µg/L	3/30	SYR4	2012–2018

4 contaminants tested, none detected

BromoformDibromoacetic AcidDibromochloromethaneMonobromoacetic Acid

Utility contact

Contact: HOOD, KEVIN
Phone: 501-767-4841
Email: [email protected]

Frequently asked questions about Mountain Pine Waterworks

Is Mountain Pine Waterworks tap water safe to drink?

EPA monitoring detected 10 contaminants in Mountain Pine Waterworks's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Mountain Pine Waterworks's water?

EPA monitoring detected Bromodichloromethane, Chloroform, TTHM, Dichloroacetic Acid, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Mountain Pine Waterworks serve?

Mountain Pine Waterworks reports serving 805 people in Arkansas, per its EPA record.

Has Mountain Pine Waterworks had any water quality violations?

The EPA has 65 violations on file for Mountain Pine Waterworks, of which 12 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.