Tap WaterIndex

← Alabama

Tap water quality report

Millry Water Works

EPA monitoring tested this supplier for 74 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

74
contaminants tested
10
detected
2,217
people served
10
health-based violations
Alabama rankingsLead in AlabamaPFAS in Alabama
Water source
Ground water
Ownership
Local government
Counties served
Washington

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

10
health-based violations
116
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2012-11-01 → 2012-11-30
MCL Health-based Resolved 2012-11-01 → 2012-11-30
MCL Health-based Resolved 2012-11-01 → 2012-11-30
MCL Health-based Resolved 2012-10-01 → 2012-10-31
MCL Health-based Resolved 2012-10-01 → 2012-10-31
MCL Health-based Resolved 2012-10-01 → 2012-10-31
MCL Health-based Resolved 2011-03-01 → 2011-03-31
MCL Health-based Resolved 2011-03-01 → 2011-03-31
MCL Health-based Resolved 2011-03-01 → 2011-03-31
MCL Health-based Resolved 2011-03-01 → 2011-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0027 mg/L 18%
of the EPA limit 0.0150 mg/L
 17/17 LCR 2024
TTHM
20 µg/L 25%
of the EPA limit 80 µg/L
worst single sample: 23.9 µg/L
11/14 SYR4 2013–2019
Copper
46.65 µg/L 3.6%
of the EPA limit 1300 µg/L
worst single sample: 57 µg/L
10/16 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
6.799 µg/L 11%
of the EPA limit 60 µg/L
worst single sample: 7.8 µg/L
8/14 SYR4 2013–2019
Barium
78.5 µg/L 3.9%
of the EPA limit 2000 µg/L
worst single sample: 80 µg/L
6/6 SYR4 2013–2019
Nitrate
200 µg/L 2%
of the EPA limit 10000 µg/L
 6/28 SYR4 2013–2019
Gross Alpha, Excl. Radon And U
1.195 pCi/L 8%
of the EPA limit 15 pCi/L
worst single sample: 1.2 pCi/L
2/2 SYR4 2016
Nitrate-Nitrite
179.5 µg/L 1.8%
of the EPA limit 10000 µg/L
worst single sample: 180 µg/L
2/6 SYR4 2013–2019
Dichloromethane
1 µg/L 20%
of the EPA limit 5 µg/L
 1/7 SYR4 2013–2019
Fluoride
150 µg/L 3.8%
of the EPA limit 4000 µg/L
 1/6 SYR4 2013–2019
64 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChloroformChromiumDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromochloromethaneDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
RIGBY, STAN
Phone
251-846-2968
Email
[email protected]

Frequently asked questions about Millry Water Works

Is Millry Water Works tap water safe to drink?

EPA monitoring detected 10 contaminants in Millry Water Works's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Millry Water Works's water?

EPA monitoring detected Lead, TTHM, Copper, Total Haloacetic Acids (HAA5), Barium, and others. The full list with the level and data source for each is above.

How many people does Millry Water Works serve?

Millry Water Works reports serving 2,217 people in Alabama, per its EPA record.

Has Millry Water Works had any water quality violations?

The EPA has 116 violations on file for Millry Water Works, of which 10 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.