Tap WaterIndex

← Alabama

Tap water quality report

Jacksonville Water Works Gas and Sewer

EPA monitoring tested this supplier for 39 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

39
contaminants tested
10
detected
14,217
people served
11
health-based violations
Alabama rankingsLead in AlabamaPFAS in Alabama
Water source
SWP
Ownership
Local government
Counties served
Calhoun

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

11
health-based violations
218
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2002-05-01 → 2002-05-31
MCL Health-based Archived 2002-05-01 → 2002-05-31
MCL Health-based Archived 1995-10-01 → 1995-10-31
MCL Health-based Archived 1995-10-01 → 1995-10-31
MCL Health-based Resolved 1995-07-01 → 1995-07-31
MCL Health-based Resolved 1995-07-01 → 1995-07-31
MCL Health-based Resolved 1995-07-01 → 1995-07-31
MCL Health-based Resolved 1995-07-01 → 1995-07-31
MCL Health-based Resolved 1995-07-01 → 1995-07-31
MCL Health-based Archived 1991-08-01 → 1991-08-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
14.63 µg/L 18%
of the EPA limit 80 µg/L
worst single sample: 19.3 µg/L
59/94 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
16.35 µg/L 27%
of the EPA limit 60 µg/L
worst single sample: 21 µg/L
34/94 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 20/20 LCR 2025
Copper
7.8 µg/L 0.6%
of the EPA limit 1300 µg/L
worst single sample: 8 µg/L
3/36 SYR4 2012–2019
Lead
2.9 µg/L 19%
of the EPA limit 15 µg/L
worst single sample: 3 µg/L
3/36 SYR4 2012–2019
Bromodichloromethane
2.425 µg/L
No EPA limit set
worst single sample: 2.5 µg/L
2/12 SYR4 2012–2019
Chloroform
10.455 µg/L
No EPA limit set
worst single sample: 10.8 µg/L
2/12 SYR4 2012–2019
Dibromochloromethane
3.26 µg/L
No EPA limit set
worst single sample: 3.4 µg/L
2/12 SYR4 2012–2019
Lithium
100 µg/L
No EPA limit set
 2/8 UCMR-5 2024
Bromoform
0.7000 µg/L
No EPA limit set
 1/12 SYR4 2012–2019
29 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfuna

Utility contact

Contact
JONES, MARK
Email
[email protected]

Frequently asked questions about Jacksonville Water Works Gas and Sewer

Is Jacksonville Water Works Gas and Sewer tap water safe to drink?

EPA monitoring detected 10 contaminants in Jacksonville Water Works Gas and Sewer's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Jacksonville Water Works Gas and Sewer's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Lead, Copper, Lead, and others. The full list with the level and data source for each is above.

How many people does Jacksonville Water Works Gas and Sewer serve?

Jacksonville Water Works Gas and Sewer reports serving 14,217 people in Alabama, per its EPA record.

Has Jacksonville Water Works Gas and Sewer had any water quality violations?

The EPA has 218 violations on file for Jacksonville Water Works Gas and Sewer, of which 11 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.