← Alaska

Tap water quality report

Diomede Joint Utilities

EPA monitoring tested this supplier for 48 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

48
contaminants tested
16
detected
83
people served
260
health-based violations
Water source
Surface water
Ownership
Native American
Counties served
Nome Census Area

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

260
health-based violations
3,009
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2025-04-01 → 2025-06-30
MCL Health-based Archived 2025-01-01 → 2025-03-31
MCL Health-based Archived 2025-01-01 → 2025-12-31
MCL Health-based Archived 2024-10-01 → 2024-12-31
MCL Health-based Archived 2024-07-01 → 2024-09-30
MCL Health-based Archived 2024-01-01 → 2024-12-31
TT Health-based Resolved 2023-07-01 → 2023-07-31
MCL Health-based Archived 2022-04-01 → 2022-06-30
MCL Health-based Archived 2022-01-01 → 2022-03-31
MCL Health-based Archived 2021-10-01 → 2021-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
4100 µg/L 315%
of the EPA limit, at the 95th percentile of samples — 1300 µg/L
41/41 SYR4 2013–2019
Lead
12.4 µg/L 83%
of the EPA limit 15 µg/L
worst single sample: 35 µg/L
39/41 SYR4 2013–2019
Arsenic
63.485 µg/L 635%
of the EPA limit, at the 95th percentile of samples — 10 µg/L
worst single sample: 84.1 µg/L
20/20 SYR4 2012–2019
Lead
0.0060 mg/L 40%
of the EPA limit 0.0150 mg/L
18/18 LCR 2025
Nitrate-Nitrite
19800 µg/L 198%
of the EPA limit, at the 95th percentile of samples — 10000 µg/L
worst single sample: 21000 µg/L
6/6 SYR4 2012–2019
Nitrate
25000 µg/L 250%
of the EPA limit, at the 95th percentile of samples — 10000 µg/L
2/2 SYR4 2017
Barium
11.6 µg/L 0.6%
of the EPA limit 2000 µg/L
1/1 SYR4 2013
Bromodichloromethane
3.65 µg/L
No EPA limit set
1/3 SYR4 2013–2017
Cadmium
0.6950 µg/L 14%
of the EPA limit 5 µg/L
1/1 SYR4 2013
Chloroform
10.2 µg/L
No EPA limit set
1/3 SYR4 2013–2017
Dibromochloromethane
2.3 µg/L
No EPA limit set
1/3 SYR4 2013–2017
Dichloroacetic Acid
2.21 µg/L
No EPA limit set
1/3 SYR4 2013–2017
Fluoride
203 µg/L 5.1%
of the EPA limit 4000 µg/L
1/1 SYR4 2013
TTHM
16.2 µg/L 20%
of the EPA limit 80 µg/L
1/3 SYR4 2013–2017
Total Haloacetic Acids (HAA5)
17.2 µg/L 29%
of the EPA limit 60 µg/L
1/3 SYR4 2013–2017
Trichloroacetic Acid
15 µg/L
No EPA limit set
1/3 SYR4 2013–2017
32 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalBenzeneBeryllium, TotalBromoformChlorobenzeneCyanideCarbon TetrachlorideChromiumDichloromethaneDibromoacetic AcidEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
AHKDALUK, KARA
Phone
907-686-3071
Email
[email protected]

Frequently asked questions about Diomede Joint Utilities

Is Diomede Joint Utilities tap water safe to drink?

EPA monitoring detected 16 contaminants in Diomede Joint Utilities's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Diomede Joint Utilities's water?

EPA monitoring detected Copper, Lead, Arsenic, Lead, Nitrate-Nitrite, and others. The full list with the level and data source for each is above.

How many people does Diomede Joint Utilities serve?

Diomede Joint Utilities reports serving 83 people in Alaska, per its EPA record.

Has Diomede Joint Utilities had any water quality violations?

The EPA has 3009 violations on file for Diomede Joint Utilities, of which 260 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.