Tap WaterIndex

← Alaska

Tap water quality report

Hillside Park S/D

EPA monitoring tested this supplier for 28 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

28
contaminants tested
5
detected
144
people served
3
health-based violations
Alaska rankingsLead in AlaskaPFAS in Alaska
Water source
Ground water
Ownership
Private
Counties served
Anchorage Municipality

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
144
violations on file
3
still open
ViolationTypeStatusPeriod
TT Health-based Unaddressed 2024-07-01
TT Health-based Resolved 2024-05-21
TT Health-based Resolved 2023-07-01
MR Monitoring Unaddressed 2025-06-16
MR Monitoring Unaddressed 2025-04-17
MR Monitoring Resolved 2024-07-01 → 2024-07-31
MR Monitoring Resolved 2024-07-01
MR Monitoring Resolved 2024-04-20
Other Monitoring Resolved 2021-10-01
Other Monitoring Resolved 2018-10-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0050 mg/L 33%
of the EPA limit 0.0150 mg/L
 18/18 LCR 2025
Copper
129.2 µg/L 9.9%
of the EPA limit 1300 µg/L
worst single sample: 131 µg/L
10/10 SYR4 2014–2017
Lead
6.462 µg/L 43%
of the EPA limit 15 µg/L
worst single sample: 6.77 µg/L
9/10 SYR4 2014–2017
Nitrate-Nitrite
5392 µg/L 54%
of the EPA limit 10000 µg/L
worst single sample: 5410 µg/L
7/7 SYR4 2012–2019
Nitrate
5150 µg/L 52%
of the EPA limit 10000 µg/L
 2/2 SYR4 2017
23 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneArsenicBenzeneChlorobenzeneCarbon TetrachlorideCombined Radium (-226 And -228)DichloromethaneEthylbenzeneStyreneTetrachloroethyleneTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
YOUNG, JESSE
Phone
907-223-2615
Email
[email protected]

Frequently asked questions about Hillside Park S/D

Is Hillside Park S/D tap water safe to drink?

EPA monitoring detected 5 contaminants in Hillside Park S/D's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hillside Park S/D's water?

EPA monitoring detected Lead, Copper, Lead, Nitrate-Nitrite, Nitrate. The full list with the level and data source for each is above.

How many people does Hillside Park S/D serve?

Hillside Park S/D reports serving 144 people in Alaska, per its EPA record.

Has Hillside Park S/D had any water quality violations?

The EPA has 144 violations on file for Hillside Park S/D, of which 3 are health-based (a contaminant limit or required treatment was breached) and 3 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.