Tap WaterIndex

← South Dakota

Tap water quality report

Marty Water

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
420
people served
0
health-based violations
South Dakota rankingsLead in South DakotaPFAS in South Dakota
Water source
SWP
Ownership
Native American

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
38
violations on file
0
still open
ViolationTypeStatusPeriod
MON Monitoring Resolved 2025-08-01 → 2025-08-31
MR Monitoring Resolved 2025-08-01 → 2025-08-31
MON Monitoring Resolved 2024-10-01 → 2024-10-31
MR Monitoring Resolved 2024-10-01 → 2024-10-31
MR Monitoring Resolved 2024-03-01 → 2024-03-31
MON Monitoring Resolved 2024-03-01 → 2024-03-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2023-09-01 → 2023-09-30
MON Monitoring Resolved 2023-09-01 → 2023-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2024
TTHM
78.995 µg/L 99%
of the EPA limit 80 µg/L
worst single sample: 81.9 µg/L
8/8 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
41.02 µg/L 68%
of the EPA limit 60 µg/L
worst single sample: 41.3 µg/L
8/8 SYR4 2014–2019
Lead
4.648 µg/L 31%
of the EPA limit 15 µg/L
worst single sample: 5.6 µg/L
5/5 SYR4 2018
Copper
172.5 µg/L 13%
of the EPA limit 1300 µg/L
worst single sample: 180 µg/L
4/5 SYR4 2018

Utility contact

Contact
ZEPHIER, DANIELLE
Phone
605-384-5012
Email
[email protected]

Frequently asked questions about Marty Water

Is Marty Water tap water safe to drink?

EPA monitoring detected 5 contaminants in Marty Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Marty Water's water?

EPA monitoring detected Lead, TTHM, Total Haloacetic Acids (HAA5), Lead, Copper. The full list with the level and data source for each is above.

How many people does Marty Water serve?

Marty Water reports serving 420 people in South Dakota, per its EPA record.

Has Marty Water had any water quality violations?

The EPA has 38 violations on file for Marty Water, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.